14.6V 36A Lifepo4 Battery Charger Introduction The use of 36A charger is as follows: First use: first connect the power supply---adjust the voltage you want---connect the battery---the charger display will turn off---unplug Turn off the power and re-plug the plug ------ normal display normal charging. The second use (the voltage is set for the first time, and there is no need to set it later)-------connect the battery first (very important, it can protect the charger)-------connect the power supply ------------ Follow the second step to use it later.
description:
Input voltage: AC 110v --220v/250v
Rated power: 460W
Output voltage: 14.6V (constant voltage, not adjustable)
Output current: 36A (constant current, not adjustable)
Appearance size: 240X38X87 (mm)
Cooling method: air cooling
Charging status: red light when charging, green light when fully charged
Accessories host/power cord (European standard, American standard optional)/clip (optional)/Anderson (optional)
Note: (The important thing is repeated three times!) The positive and negative poles of the battery cannot be reversed (red positive +; black negative -). Reverse connection will cause damage (damage is not guaranteed). AC 110V-250V.
Special instructions for 60A / /85A/100A charger: first plug the charger into the power supply-----check the voltage---adjust the voltage with a screwdriver-----connect the load----- then adjust the current .
Step1: Do not connect the battery to the charger, turn on the power, adjust the voltage knob to adjust the voltage, refer to the voltage display at the top of the display, (4S lifepo4 battery 3.65 v*4=14.6V, 3S lithium battery 4.2v *3=12.6V), adjust to the voltage you need (you can adjust the voltage in combination with a multimeter. The display will have a small error.).
Step2: Adjust the current to the minimum. After connecting the battery, adjust the current from small to large to the current you need. (It is not allowed to adjust the voltage knob again during the charging process, otherwise there will be overcharge or undercharge, which may burn the host) If the voltage is displayed and the current becomes zero, it means that it is fully charged.
Step3: When using it later (the voltage has been set for the first time, no need to set it later) ------- connect the battery first (very important, it can protect the charger) ------- then connect the power supply- ---------Follow this step for later use, no need to adjust the voltage and current (unless you want to modify it)
Do not adjust the charger voltage while charging. The voltage of the charger itself fluctuates, and it is normal to charge the battery with constant voltage. When the battery is fully charged, the current on the charger display will show zero or near zero. If you do not understand, please consult customer service!
To extend the life of the charger. The charger has a voltage of 220V, and the maximum recommended current is 90%, for example, 60A. It is most suitable to adjust it to about 54A. The maximum recommended voltage and current of 110V is 80%, and the maximum recommended voltage and current of 100V is 70%.
Video operation method:
//youtu.be/yjw-F0yLt-8
